8 ch 2.4GHz Detrum SR86A Receiver With ISTONE Stabilizer With ABS

Code: AD0405
£44.99
  • Out of stock
For all stock enquiries relating to this product please enter your email address below:

DYNAM DETRUM SR86A 8CH 2.4G RECEIVER w/ISTONE STABILZER (w/ABS)

Main Control IC: 32-bit high-performance ARM core processor, 6-axis MEMS gyro chipset

Control Algorithm:

Original airplane attitude stabilization algorithm and control algorithm. Supports normal wing, flying wing, V-tail airplanes, and 3D planes.

Flight Mode:

Four flight modes: Gyro off, Normal, Aerobatic, and Auto-Recovery (Auto Balance). You can switch between different modes by the toggle switch.

Adjusting the Gain:

Set the gain and other programmable items with matched transmitter.

High Sensitivity:

SR86A adopts 2.4GHz direct sequence spread spectrum (DSSS) and multiple frequency-hopping (FHSS) technologies, this gives high receiving sensitivity and strong anti-interference capability.

Twin Antennas:

By using twin antennas, combined with the signal detection and switching algorithm, the receiving signal is stable and reliable.

Unique ID Code:

Once the receiver is bound to the transmitter, the ID code is stored in the receiver and no further binding is necessary after restarting the receiver.

Fail Safe:

If the aircraft flies out of the remote control range and cannot receive a valid RF signal from the transmitter, SR86A’s outputs can be driven to their preset failsafe positions.

Spec Check:

Channels: 8-channel

Sensor: 6-axis gyro

Sensitivity: -97dBm

Output: PWM (71Hz)

Transmission Range: More than 1,000 metres on the ground, more than 1,600 metres in the air

Input Voltage: 3.6V ~ 16V

Size: 51mmx28.4mmx14.5mm

Weight: 15g